噪声前置放大器是磁共振射频接收子系统中的重要组件，它的性能优劣直接决定了最终磁共振图像的好坏.目前市场上的低噪声前置放大器大多基于中高场磁共振系统开发，而针对低场磁共振系统的很少；另外，商用低场磁共振系统的低噪声前置放大器价格相对较贵，并且多采用两级放大结构，结构复杂、调试难度大、成本相对较高.在此背景下，针对0.5 T低场磁共振设备利用Keysight公司的先进设计系统（ADS）软件对低噪声前置放大器进行研究设计，采用一级放大结构，探索电路设计与布局对放大器性能的影响.实测结果表明自主设计的低噪声前置放大器在21 MHz共振频率附近噪声系数为0.5 dB左右，增益达到了30 dB，能够满足低场磁共振应用的要求.
亢科
,
杨晓冬
,
徐雅洁
,
张闻文
. 低场磁共振系统的低噪声前置放大器研究设计[J]. 波谱学杂志, 2017
, 34(3)
: 383
-395
.
DOI: 10.11938/cjmr20162547
Low noise pre-amplifier is an important component in the radiofrequency (RF) receiving subsystem of magnetic resonance systems. The performance of pre-amplifier determines the quality of the final images directly. Currently, low noise pre-amplifiers on the market mostly are designed for high-field magnetic resonance systems. Few such low noise pre-amplifiers were designed specifically for low-field magnetic resonance systems. Moreover, commercially-available low noise pre-amplifiers are relatively expensive, and most of the designs use a complicated two-stage amplification structure. For these reasons, a low noise pre-amplifier with only one-stage amplification structure was developed in this study for 0.5 T low-field magnetic resonance systems using the advanced design system (ADS) software. The circuit design and layout effects were presented. Experimental measurement showed that the noise figure of on-resonance frequency 21 MHz was about 0.5 dB, and a gain of 30 dB was achieved.
[1] ANDERS J, BOERO G. A Low-noise CMOS receiver frontend for MRI[C]. IEEE Biomedical Circuits and Systems Conference-Intelligent Biomedical Systems, 2008:168-168.
[2] MUELLER O M. Unconditionally-stable ultra low noise R.F. pre-amplifier[P]. USA:4835485. 1989-05-30.
[3] DE ROOIJ M A, GIAQUINTO R O J, BURDICK J R W E, et al. Integrated low noise amplifier and balun for MRI receivers[P]. USA:7378851. 2008-05-27.
[4] 黄璐巍. 一种能降低低频噪声的磁共振成像MRI系统前置放大器[P]. 中国:201541238, U. 2010-08-04
[5] 赵欣. 低场脉冲磁共振前置放大器的分析与研制[D]. 北京:中国科学院电工研究所, 2006.
[6] FENG W. Design of low noise preamplifier for 0.5 T small joint MRI instrument[J]. Foreign Electronic Measurement Technology, 2016, 7(35):71-74. 丰伟. 0.5 T小型关节MRI仪器中低噪声前置放大器的设计[J]. 国外电子测量技术, 2016, 7(35):71-74.
[7] 冯永革. 低噪声放大器的研究与设计[D]. 南京:南京理工大学, 2015.
[8] 张凯. 小型化高性能的低噪声放大器[D]. 济南:山东大学, 2009.
[9] CAO X M, ZU D L, ZHAO X N, et al. The design of a low-noise preamplifier for MRI[J]. Sci China:Tech Sci, 2011, 54(7):1766-1770. 曹学明, 俎栋林, 赵旭娜, 等. MRI低噪声前置放大器设计研究[J]. 中国科学:技术科学, 2011, 54(7):1766-1770.
[10] 郝胜. 2.4 GHz接收机射频前端设计[D]. 南京:南京理工大学, 2006.
[11] WU P. LNA Circuits design based on E-PHEMT[J]. Global Electronics China, 2006, 1:33-36. 吴鹏. 基于E-PHMET的LNA的电路设计[J]. 世界电子元器件, 2006, 1:33-36.
[12] LIU S M, TIAN L Q. Applying the feedback technique to the broadband LNA design[J]. Journal of Telemetry, Tracking and Command, 2007, 28(3):59-63. 刘抒民, 田立卿. 使用负反馈技术设计宽带低噪声放大器[J]. 遥测遥控, 2007, 28(3):59-63.
[13] YEOM K W. Microwave circuit design-a practical approach using ADS[M]. USA:Pearson Education, Inc., 2015:407-414.
[14] BECK B L. Noise parameter extraction in the design of low noise amplifiers (LNA) for MRI[C]. National High Magnetic Field Laboratory 2007 Research Report, 2007.
[15] MAO W J, RAN L X, JIN Z H, et al. Design of RF LNA match circuits for the best noise performance of receiver[J] Journal of Circuits and Systems, 2002, 7(3):21-24. 毛文杰, 冉立新, 金仲和, 等. 一种基于接收机整机噪声最佳的射频LNA匹配电路设计[J]. 电路与系统学报, 2002, 7(3):21-24.
